Tag Archives: Water Blog

Why Treating Batches Of Water Is Necessary To Live?

According to many climatologists and political scientists the next world war may very well be caused by disputes, not over oil, but over a far more precious resource – water. Changing climate patterns and widespread pollution are placing resources of fresh and potable water under enormous strain and making it more necessary than ever before to conserve and treat to the water that we use.

John Adams from Neopuretech quoted, “The science of water treatment has therefore become more important than ever.”

It is not only drinking water that is of paramount importance, fresh or treated water is an essential component for industrial processes, medicine and agriculture. All of these are at the foundation of modern society.

Water treatment is a large scale industrial process that removes contaminating matter from the water so that it is suitable for the end user. For more information about purification of water, visitĀ coolingtowerwater.weebly.com

There are a number of processes that can be used in water treatment and these include both mechanical and chemical methods.

The first, mechanical processes can consist of allowing larger solids to settle at the bottom of large concrete lined ponds and then pumping the water to parts of a water treatment plant where further processing can take place. The second commonly used mechanical process is filtration. The most widely used filtration method in the treatment of water is sand filtration.

In sand filtration the waste water flows through a bed of extremely fine sand and in some instances larger pebbles which act to trap particles. At this stage of the water treatment process the majority of the remaining suspended particles are removed from the water.

There are many chemical processes involved in water treatment. However, the most common are the use of calcium hydroxide and chlorine.

Calcium hydroxide issued in the process of ‘flocculation’. Adding calcium hydroxide to the water causes very small particles to adhere to each other, making them much easier to filter out. Sodium silicate and ferric chloride may also be added to the water as these aid in the process of flocculation.

Without this process, many mechanical filters would be much less useful, says the author fromĀ coolingtowertreatment.wordpress.com

Chlorine is commonly used in almost every water treatment plant in the world.

Chlorine is carefully added in measured doses to the water to ensure that it reaches levels where it is safe to drink and be used in a variety of other industrial applications. The chlorine acts to kill quickly a wide variety of micro-organisms, bacteria and any viruses that might be present after mechanical filtration has taken place.

Chlorine doesn’t remain active for very long, around 8 hours is maximum, so it is used again at the pumping station as a weaker solution (along with small doses of ammonia) to ensure that the water remains safe to use right until it reaches the consumer or industrial user.

As potable water becomes more and more scarce new technologies for the treatment of sewage are becoming more common, include treatment with ultra-violet radiation and a variety of reverse osmosis treatments. As we move deeper into the 21st century, it is going to become more and more important that we continue to innovate as far as treatment is concerned, but that we also learn to husband our water resources more carefully.

Greatest Water Treatment Available?

If you have an HVAC system that is in your home, or if you have a large one installed at a factory, the way that everything is cool down is using a cooling tower, and some problems are inherent with this type of setup. The purpose of the tower is to remove all of the heat that is produced every time the motors are running. They can also be used to cool the compressor refrigerant, but they are most well-known for removing the compressor heat itself. The process is called latent heat of vaporization, and it is possible for a single pound of water to remove 1000 BTUs of heat. However, some problems will show up on these particular cooling systems, beginning with the cycles of concentration.

What Are The Cycles Of Concentration

This only refers to the amount of solid particulate matter that happens to be in the water in comparison to water that has not been used or is not contaminated. The higher the number, the more likely it is that the cooling tower can be compromised by everything that accumulates in the water that is being used. This is why water treatment for a cooling tower is so necessary because it can blow over the contaminated water that is continuously recirculated. This can also include biological contaminants, and if left unchecked, it can inhibit proper heat transfer, and lead to the corrosion of the tubes that are used to extract the heat, leading to the possibility that the entire system will be compromised.

4 Most Common Problems And Solutions

The most common problems that are associated with the water in the cooling towers include scale, bacteria, corrosion and what is called biofilm. Level represents the amount of solid particulate matter in the water which contains inorganic salts which can severely restrict heat exchange. Biofilm refers to microorganisms that can also be deposited internally on the metal surfaces of the tubes. That is why chlorine or broke mine is used to improve these problems, along with chlorine dioxide gas. Bacteria, and other common problem can be easily removed using these solutions. Corrosion typically occurs in the form of what is called white rust, the corrosion of the metal due to microorganisms that can produce hydrogen sulfide and sulfuric acid, both of which can eat away at the metal.

As long as you are using galvanized steel for the water tower, you shouldn’t have any problems with white rust caused by bacteria. Additionally, corrosion will be eliminated, along with most biofilm-related problems, or degradation equipment. It is always good to have a tower water treatment from time to time that can extend the life of your unit. Regardless of size, it is imperative that you address all four of these potential issues with the aid of a professional water tower treatment specialist that can actually extend the life of your water tower for many years.